Microdialysis Probe

Catalog

Microdialysis Probe

The guide cannula, dummy and probe are each sold separately. We will custom cut each component for your model.
All probe connectors are spring covered.
The probe will mate with our 21ga guide and corresponding cannula dummy.

Please note the form and chart below. The form allows you to choose the specifications to custom build a probe.

We do not recommend re-use of these probes.

HOW TO CUSTOM BUILD YOUR MICRODIALYSIS PROBE ASSEMBLY

PROBE END:

1)First, choose a membrane pore size:

2)Last, we will need lengths for ALL the following variables: (please see diagram above)
A- Length of membrane below injector tip (mm)
minimum =2mm maximum =5mm including 0.5mm glue at tip
B- Length of guide below pedestal (mm)
C- 5MM or 8MM pedestal (guide)

CONNECTOR END:

D- Length of PE 20 connector tubing & fused silica (centimeters)
from swivel to guide (PE & FS minimum length=20cm)

E- Dummy wire projection beyond guide tube (mm)

Part Number and Description Chart

Part Number	Part Description	A Length of membrane (mm) NOTE: Min.length-2mm Max.length-5mm	B Length of guide below pedestal (mm)	C 5MM or 8MM Pedestal	D Length of PE CONNECTOR tubing/fused silica (cm) NOTE: PE & FS min.length=20cm	E Dummy wire projection beyond guide tube (mm)	Spring Length
HMD-1/CS	13KD with spring	Specify	Specify	Specify	Specify	Specify	Specify
HMD-2/CS	18KD with spring	Specify	Specify	Specify	Specify	Specify	Specify

Hollow Fiber Specifications:
*2 MWCO's:*	*Working Volume:*
13 and 18 kD	5 µl/fiber
*Fiber OD:*	*Surface Area / Length:*
216 µm	6.3 mm2/cm
*Fiber ID:*	*Volume / Length:*
200 µm	0.31 µl/cm

*Q-Factor: 20
Fused Silica dimension: = .0029" × .0059"

*Q-factor is the ration between membrane surface area and volume.
The Q-factor should be as high as possible for maximum efficiency
and to reduce dialysis time.

This Item Mates with the following other items:

Simultaneous Bipolar Electrode-Microdialysis System

Admin