Products  Cannula Systems Connector Assemblies
Syringe Details here
Plastics One is excited to announce the arrival of a precision syringe, specifically made for use with your existing components. This new syringe, manufactured by the renowned Hamilton Company, allows for precise liquid measurement up to 1µL. A stainless steel needle and a tungsten plunger wire allows for 100% sample distribution, when the plunger is fully depressed. The syringe fits both our single and double connector assemblies, as well as our PE50 tubing.
|  |
|
Products Electrode Systems 6 Channel Cables
363 Plug with pins only Details here
Designed to allow the customer to make their own cable that will be compatible with our MS363 Electrode Pedestal,
this molded 363/CP plug is loaded with six 363A male pins and comes with a threaded captive collar (363 Collar).
|  |
|
Products Cannula Systems MRI Compatible
Non-Metallic Bilateral Guide Details here
Guides a Bilateral Internal to the injection site. Consists of a cylindrical plastic pedestal molded around two pieces of PEEK tubing (22ga equivalant) that extend below the pedestal. The pedestal is secured with Cerebond or dental cement and mounting screws.
Uses 363DC dustcap.
A polyester mesh option is also available if needed as an attachment to the guide pedestal.
Note! There is no Connector Assembly for the C232G/5.0/PK - use PE50 tubing and 363C collar.
| O.D. of peek tubing |
I.D. of peek tubing |
Pedestal Height |
Pedestal Width |
| .711mm (.028") |
.406mm (.016") |
8.0mm(.315") |
7.7mm(.303") |
Click here for information about PEEK |  |
|
Products Cannula Systems MRI Compatible
Non-Metallic Back-Mount Cannula Connector Pedestal Details here
The plastic pedestal consists of a threaded cylindrical top on a base molded around a teflon or PEEK tube that projects to the side of the base. The base comes with a polyester screen mesh attached for mounting on the back. The skin will grow into the mesh and secure it.
Available in lengths up to 11MM.
Available with the polyester mesh located above or below the side tubing.
Upward Projection: 3mm (.12")
Mesh Diameter: 25mm (1")
Click here for information about PEEK |  |
|
Products Cannula Systems MRI Compatible
Non-Metallic Guide Details here
Guides an Internal to injection site. Consists of a threaded cylindrical plastic pedestal molded around a piece of Teflon, fused silica or PEEK tubing that extends below the pedestal. The pedestal is secured with Cerebond or dental cement and nylon mounting screws.
A polyester mesh option is also available if needed as an attachment to the guide pedestal.
Pedestal Height: 8.0 mm (.315").
Pedestal Diameter: 3.5 mm (.138").
|  |
|
|
